Skip to content

How to make bird toys at home for cockatiels and small cages

By Erick Updated 10 min read

As an Amazon Associate I earn from qualifying purchases. That costs you nothing and does not decide what gets recommended. We also earn a commission from some links to partner brands (POPOSOAP, Kiwibit Inc.).

On this page (8 sections)
  1. The short version
  2. What you need
  3. Safer materials for birds
  4. Match size to the bird
  5. Simple toy assembly
  6. Safety checks and space
  7. Common mistakes and emergencies
  8. Questions people still ask

In short: Make bird toys at home from confirmed untreated wood, plain paper, and natural-fibre rope. Use stainless steel hardware. Match each toy to your bird's body and behaviour. A small bird's toy should be noticeably smaller than its spread wings and must not block primary flight paths.

Part of our guide on rope perch for 1 inch bars

The unsafe part is often a small detail: an unknown clip, a loose fibre, or a toy too heavy for the bird holding it.

At a glance
Toy sizeProportionate to the bird, beak, and wingspan
Cage layoutLeave a clear primary flight path
Rope typeConfirmed untreated natural fibre
HardwareStainless steel from a reputable supplier
InspectionBefore hanging and after chewing changes
Emergency signsLethargy, vomiting, diarrhea, breathing trouble, or sudden behaviour changes

The short version

  • Use wood with a confirmed species and treatment history. Skip cedar, treated lumber, coatings, and unknown scrap wood.
  • Choose toy parts proportionate to your bird's body, beak, wingspan, and chewing strength.
  • Use stainless steel hardware from a bird-supply source when possible. Avoid galvanized and plated metal.
  • Inspect the finished toy before hanging it, then remove it when knots loosen, fibres fray, or parts crack.
  • Leave a clear flight path and watch how your individual bird handles the toy.

What you need

Lay everything out before cutting. A clear materials list keeps unknown clips and treated scrap out of the cage.

The cost stays low if you already have basic supplies. The initial purchase of rope and hardware is usually the main expense. Buy small quantities until you know what your bird enjoys.

  • Rope: confirmed untreated sisal or unbleached cotton sold for bird use. Check the label for fibre content, dyes, oils, waxes, and coatings.
  • Hardware: stainless steel quick links or bird-toy connectors from a reputable pet-bird supplier. Choose a connector the bird cannot open or fit its beak into.
  • Wood: untreated balsa, pine, birch, or maple from a bird-supply seller or a timber seller who can confirm the species and treatment history.
  • Paper: plain paper or cardboard without glossy coatings, heavy ink, adhesive, or plastic film.
  • Tools: sharp scissors, a drill with a bit chosen for your rope, and sandpaper for rough edges.
  • Skip glue, tape, paint, varnish, dyed yarn, unknown leather, and plastic parts with no clear material information.
ElaraBerry 20 Pcs 304 Stainless Steel Quick Links M3.5 1/8 Inch
What you'll need

ElaraBerry 20 Pcs 304 Stainless Steel Quick Links M3.5 1/8 Inch

Stops you having to rig connectors from unknown metal by giving a confirmed 304 stainless quick link with a 0.23 in opening, so toys hang on a fully closing, rust‑resistant connector.

Safer materials for birds

a pale balsa block beside a stained pressure-treated board for contrast
a pale balsa block beside a stained pressure-treated board for contrast

A scrap board from a garage can look harmless. It might come from a pallet, painted project, or treated deck. Birds chew and swallow small pieces, so the wood's history matters.

Common bird-toy materials include untreated pine, balsa, birch, maple, plain paper, cardboard, palm leaf, loofah, and suitable natural-fibre rope. A bird-supply seller can provide clearer treatment information than an unknown offcut. The other half of this decision is materials budgies can chew.

Cedar, pressure-treated lumber, painted wood, varnished wood, and stained wood are poor choices. Aromatic wood oils and treatment chemicals are commonly reported bird-health risks. Ask an avian veterinarian before using any questionable wood. The Association of Avian Veterinarians' companion-bird care guidance supports avoiding fumes, coatings, and unsafe household materials.

Galvanized metal can release zinc if chewed, a documented risk in pet birds. Prefer stainless steel hardware. VCA Animal Hospitals describes zinc toxicosis in birds and advises prompt veterinary care for suspected exposure. Source: VCA Animal Hospitals, “Zinc Poisoning in Birds.”

A pale colour or clean smell does not prove wood is untreated. Sanding also cannot remove chemicals through the whole board. Buy wood with a documented species and treatment history instead. If that sounds like your situation, read up on bird boredom cures next.

Common materials for small pet birds
MaterialChoiceNotes
Untreated pine or balsaUsually suitableConfirm species and treatment history
Birch or mapleUsually suitableUse clean, untreated pieces
CedarAvoidAromatic oils are a commonly reported respiratory risk
Pressure-treated lumberAvoidTreatment chemicals can remain in the wood
Natural sisalSuitable when confirmedRemove it when fibres loosen or fray
Galvanized hardwareAvoidZinc exposure is a documented concern
Stainless steelPreferredBuy from a reputable bird or pet supplier

Match size to the bird

A budgie and an African grey do not need the same toy. Their wingspans, beaks, body weights, grip strength, and chewing habits differ. Individual birds within one species also vary.

Choose a toy's widest part so it is clearly smaller than your bird's spread wings. Hold the toy beside the bird's wingspan, then place it where the bird can reach it without losing a main route between perches. This is a practical sizing method, not a fixed species chart.

A practical weight test is simple. The bird should move or manipulate the toy without obvious struggle. If the toy pulls the bird off balance, swings hard when touched, or cannot be shifted with the beak or foot, use lighter or smaller parts.

Large birds and heavy chewers need stronger supervision, not just larger pieces. Use connectors rated for the load, attach them directly to a sound cage bar, and avoid any part the bird can bend, crack, or swallow. There is no reliable universal toy-weight limit for every species and cage. Ask an avian veterinarian or experienced avian behaviour professional to assess a large or powerful bird's setup.

Keep the cage usable. Leave a clear flight path approximately equal to the bird's wingspan, with room to turn and land. Hang toys beside activity areas rather than across the main route. A bird with room to move can choose whether to play.

Questions to ask when sizing a toy
CheckWhat to look forChange to make
WingspanThe toy does not obstruct a full wing movementMove it or choose a smaller design
Beak and feetThe bird can grip or shred parts safelyUse parts sized for that bird's beak
MovementThe bird manipulates it without obvious struggleReduce weight or replace hard pieces
Cage routeThe main path between perches stays openHang the toy beside, not across, that path
Chewing strengthThe bird cannot quickly split or bend hardwareUse stronger bird-rated hardware and supervise

Simple toy assembly

A shredding toy is a good starting point. It uses paper, soft wood, and rope, so you can see how your bird plays before building anything more complex.

Cut wood pieces to a size your bird can grip and chew without covering its face or blocking its wings. Hold each piece beside your bird for comparison rather than copying a fixed measurement.

Drill a hole through each piece. Use a drill bit slightly larger than your rope's diameter so the rope passes through without forcing but not so large that blocks slide freely.

Cut enough rope for the toy to hang without forming a loop around a foot or neck. Trim loose ends and discard any piece that begins to split into long strands.

Thread a simple pattern of wood, paper, and cardboard. Tie knots between layers if you need spacing. Use no glue.

Attach the top to a stainless steel quick link. The connector should close fully and sit against the cage bar without leaving a gap large enough for a beak or toe.

Hang the toy beside a perch, not over food or water. Watch the first play session. A frightened bird may need the toy moved farther away, made smaller, or removed.

  1. Choose parts your bird can grip, shred, or move without obvious strain.
  2. Drill holes with a bit slightly larger than the rope diameter. Test one piece before drilling the rest.
  3. Thread wood, paper, and cardboard in a simple pattern.
  4. Tie secure knots and trim loose strands before hanging.
  5. Attach the toy to a closed stainless steel quick link.
  6. Place it beside a perch while keeping the main flight route open.
  7. Supervise the first session and change the design if the bird struggles or panics.
Twisted Sisal Rope 1/4" x 100ft
What you'll need

Twisted Sisal Rope 1/4" x 100ft

Gives untreated natural sisal rope you can use for toy construction with a published 1/4 in diameter and stated '100% natural sisal fibers', so you get chemical‑free rope for shredding toys.

Safety checks and space

close-up of fingers checking a sisal rope toy for loose fibres
close-up of fingers checking a sisal rope toy for loose fibres

Inspect a new toy before it enters the cage. Pull the knots, feel every wood and metal edge, and look for loose fibres, cracks, gaps, and parts the bird could swallow. Sand a rough edge or discard the piece.

Inspect again whenever chewing changes the toy. A toy that was sound can become unsafe after a session. Remove it when rope separates into loose strands, wood splits, hardware bends, or knots loosen.

Watch the bird during play. Remove a toy if it catches a toe, traps a beak, sheds long fibres, or causes repeated panic. Rotate toys only when the cage still has a clear flight path and easy access to food, water, and perches.

These precautions reflect accepted avian-care advice rather than a single legal toy standard. The Association of Avian Veterinarians provides companion-bird welfare and husbandry guidance, but no universal law sets one construction recipe or toy weight for every pet bird. Product makers may follow internal testing or retail safety rules. Those rules do not replace species-specific veterinary judgment.

Common mistakes and emergencies

Unknown hardware is a common mistake. Galvanized or plated clips can expose a chewing bird to zinc, so replace them with confirmed stainless steel hardware.

Long loops can catch toes or feet. Cut away loose strands and retire rope once it starts separating. Hard or heavy parts can injure a bird during a panic flight, so choose parts it can move without obvious struggle.

Glue, tape, paint, and unknown coatings add materials the bird can chew and swallow. Knots and confirmed bird-safe parts are easier to inspect.

If you suspect metal exposure or swallowed material, remove the toy and keep the bird quiet in a secure carrier. Do not induce vomiting, give home medicines, or wait for symptoms. Contact an avian veterinarian or emergency clinic immediately.

Lethargy, vomiting, diarrhea, breathing trouble, weakness, loss of balance, refusal to eat, or sudden behaviour changes need urgent veterinary advice. Take the toy and its packaging with you. A veterinarian can decide whether imaging, blood tests, or treatment is needed.

The verdict

Homemade toys can provide safe chewing and foraging when every material is confirmed, each toy suits the individual bird, and the cage keeps a clear flight route.

Questions people still ask

Can I use rope from a hardware store for bird toys?

Only if the seller confirms the fibre and treatment. Plain, untreated natural sisal or unbleached cotton may suit some birds. Avoid waxed, oiled, dyed, coated, or synthetic rope. Rope sold specifically for bird toys usually provides clearer product information.

How many toys should a cockatiel have in a small cage?

There is no safe number for every cage. Start with one toy, then add or rotate only if your bird still has a clear flight path, easy perch access, and room to turn. Cage shape, bird size, and toy volume matter more than a fixed count.

How often should I replace homemade bird toys?

Replace a toy when rope separates, wood cracks, knots loosen, or hardware bends. Heavy chewers can destroy a toy quickly. Inspect it whenever chewing changes its shape, rather than relying on a fixed replacement date.

Are cardboard toilet paper tubes safe for birds?

Plain cardboard may suit some birds. Remove tubes with glossy print, plastic film, heavy adhesive, or unknown residue. Watch the bird while it shreds the tube, and discard it if the cardboard becomes wet or breaks into swallowable pieces.

What wood should I never give my bird?

Avoid cedar, pressure-treated, painted, varnished, stained, or unknown wood. Buy untreated bird-safe wood with a confirmed species and treatment history. Ask an avian veterinarian about any plant or wood not listed by a reliable bird-care source.

What should I do if my bird chews galvanized metal?

Remove the item and contact an avian veterinarian promptly. Do not wait for signs of illness or give home treatment. Zinc exposure can require urgent assessment, especially if the bird shows lethargy, vomiting, diarrhea, breathing trouble, weakness, or sudden behaviour changes.

I have kept cockatiels for years and still lose DIY toys to their beaks. I now build small, watch the first session, and replace parts as soon as chewing changes them. Species and individual behaviour always come first.